The R7 RESCUE concept was developed together with the Swedish Sea Rescue Society, SSRS. This resulted in a safe, comfortable and practical suit, anatomically designed with no restraints during active work. The waterproof and breathable Quad-Lam fabric has a top layer of 330 D Cordura to ensure good durability. The protected front TIZIP Master Seal 10 zipper is more flexible and easier to open and close than conventional zippers. The telescope torso enables good fit for different bodysizes and the suit is equipped with comfortable superstretch glideskin neoprene seals at neck and wrists. Knees and elbows are padded and covered with an extra layer of heavy duty Cordura fabric. Double convertible pockets on the thighs and low profile internal pockets on the arms to ensure good storage possibilities. The lightweight neoprene softboots enhance grip, control and comfort, also compatible with flippers.
ARM POCKETS – Low profile internal pockets located at the front of both arms for easy access.
BREATHABLE – Breathable Cordura Quad-Lam fabric.
CORDURA REINFORCED ELBOWS – Elbows are padded and reinforced with an extra layer of hardcore 500D Cordura fabric.
CORDURA REINFORCED KNEES – Knees are reinforced with an extra layer of hardcore 500D Cordura fabric. Knees and elbows are also padded for enhanced protection.
Dual Convertible Pockets – Allow easy selection of huge capacity or slim profile based upon your need.
HIGH VISIBILITY – Reflective areas on all the important places.
SEAT REINFORCEMENT – Seat is reinforced with an extra layer of hardcore 500D Cordura fabric.
SUPERSTRETCH NECKSEAL – Very flexible, warm and comfortable neckseal in superstretch Glideskin Neoprene. Less friction due to the glideskin surface.
SUPERSTRETCH WRISTSEALS – Very flexible, warm and comfortable wristseals keeps your arms dry and warm. Less friction due to the Glideskin surface.
TIZIP DRYZIPPER – Very light and flexible dryzipper from TI-ZIP. Protected by a zipper cover.
XLITE FLEXBOOT – Comfortable and light weight Flexboot in Neoprene for good grip and control.
Our breathable drysuit fabric is highly waterproof due to the PU layer, but improper usage or storage could damage the PU layer and decrease the waterproof capability. It is very important that you rinse and clean breathable drysuits after each dive and let them dry completely both inside and outside. Please follow the care instructions below carefully to maintain the sufficient performance of your drysuit.
Cleaning;
If dirt, salt, oil, or sweat gets on the fabric, rinse off immediately with fresh water. Drain off the water from the garment and dry completely both inside and outside in the shade.
Leaving the garment without rinsing off dirt for long periods may increase the deterioration of the PU layer, which may reduce the waterproof capability, or may cause the delamination of the PU layer.
Do not store the drysuit wet, as this may cause the delamination of the PU layer.
Do not wring or knead the drysuit, especially when it is wet, as this may cause the delamination of the PU layer.
Do not expose the drysuit to direct sunlight for long periods, as this may cause the delamination of the PU layer, and may also decrease the strength of the fabric.
Even if the garment gets extremely dirty, do not machine wash. Hand wash with laundry detergent, brush off the dirt and rinse thoroughly. If the detergent remains on the fabric, it may reduce the waterproof capability of the fabric, or may cause the delamination of the PU layer.
Storage;
Wash and dry properly, both inside and outside. Do not leave the drysuit in a wet condition.
Do not store in hot and humid conditions (such as in a car, near a radiator or a stove).
Store away from direct sunlight.
Do not store with dirt or salt left on the drysuit.
Do not fold the drysuit forcibly or place under any heavy object.
Size availability is subject to change without notice. Please contact your Waterproof retailer for availability.
R7 Rescue, Art. No. 451
Newsletter |
